Unable to create DataSet using IPv4 CIDR format using GUI
Article ID: CTX587684
Updated On:
Description
When attempting to add a dataset via the GUI (AppExpert > Data Sets -> Add), users may encounter a failure accompanied by the error message - "Value entered is not an IPv4."
Note: This error message specifically occurs when the subnet mask value (n) is greater than 28 (a.b.c.d/n)
Resolution
The issue is addressed in following versions :
- 14.1 15.12+
- 13.1 52.9+
Problem Cause
The identified issue is a known problem documented under the reference number NSHELP-36659.Issue/Introduction
Unable to create DataSet using IPv4 CIDR format using GUI
Was this article helpful?
Yes
No
Powered by
