How to change Logstream source IP to NSIP on ADC.
Article ID: CTX286215
Updated On:
Description
By default, Logstream communication from ADC to ADM uses the SNIP address to source traffic. Administrators may wish to use the NSIP for this communication. Prior to the introduction of Logstream, the IPFIX protocol used NSIP so customers may want to maintain this flow.
Instructions
To set the NSIP as the source IP for Logstream communication from GUI, Navigate to System/Appflow/Configure Appflow Settings and check the box for "Logstream over Citrix ADC IP".From CLI:
set appflow param -logstreamOverNSIP ENABLED
Additional Information
https://support.citrix.com/article/CTX227438
Was this article helpful?
Yes
No
Powered by
