Enrolling Android device without using user's google account to configure device

Instructions

Provision work-managed device mode for Android for Work

Work-managed device mode for Android for Work is available for corporate-owned devices only. XenMobile supports these methods of enrollment in work-managed device mode:

• afw#xenmobile: With this enrollment method, the user enters the characters “afw#xenmobile” when setting up the device. This token identifies the device as managed by XenMobile and downloads Secure Hub.
• QR code: QR code provisioning is an easy way to provision a distributed fleet of devices that do not support NFC, such as tablets. The QR code enrollment method can be used on fleet devices that have been reset to their factory settings. The QR code enrollment method sets up and configures work-managed device mode by scanning a QR code from the setup wizard.
• Near field communication (NFC) bump: The NFC bump enrollment method can be used on fleet devices that have been reset to their factory settings. An NFC bump transfers data through between two devices using near-field communication. Bluetooth, Wi-Fi, and other communication modes are disabled on a factory-reset device. NFC is the only communication protocol that the device can use in this state.

afw#xenmobile

The enrollment method is used after powering on a new or factory reset devices for initial setup. Users enter “afw#xenmobile” when prompted to enter a Google account. This action downloads and installs Secure Hub. Users then follow the Secure Hub set-up prompts to complete the enrollment.

In this enrollment method is recommended for most customers because the latest version of Secure Hub is downloaded from the Google Play store. Unlike with other enrollment methods, you do not provide Secure Hub for download from the XenMobile server.

Prerequisites:

• Supported on all Android devices running Android 5.0 and above.

QR code

To enroll a device in device mode using a QR code, you generate a QR code by creating a JSON and converting the JSON to a QR code. Device cameras scan the QR code to enroll the device.

Prerequisites:

• Supported on all Android devices running Android 7.0 and above.

Create a QR code from a JSON

Create a JSON with the following fields.

These fields are required:

Key: android.app.extra.PROVISIONING_DEVICE_ADMIN_COMPONENT_NAME

Value: com.zenprise/com.zenprise.configuration.AdminFunction

Key: android.app.extra.PROVISIONING_DEVICE_ADMIN_SIGNATURE_CHECKSUM

Value: qn7oZUtheu3JBAinzZRrrjCQv6LOO6Ll1OjcxT3-yKM

Key: android.app.extra.PROVISIONING_DEVICE_ADMIN_PACKAGE_DOWNLOAD_LOCATION

Value: https://path/to/securehub.apk

Note:

If Secure Hub is uploaded onto Citrix XenMobile server as an enterprise app, it can be downloaded from https://<fqdn>:4443/*instanceName*/worxhome.apk. The path to the Secure Hub APK must be accessible over the Wi-Fi connection that the device connects to during provisioning.