There are a number of messages that normally appear on the ELM VM console that are in fact benign and not an indication of any problem. These are messages that Linux outputs internally and not errors or problems reported by the App Layering software. These are normal messages that are produced during file share and layering disk operations. Ignore them.

As shown on the console, these messages are of the form "[seconds since boot] text". The specific content of your messages will differ from these examples because we have removed the timestamp, and there will also be device ID differences.



Example benign messages:

 nbd1279:
 nbd1279: p1
 nbd1278:
 nbd1278: p1
block nbd1277: Write on read-only
blk_update_request: I/O error, dev nbd1277, sector 0
block nbd1277: NBD_DISCONNECT
block nbd1277: Receive control failed (result -32)
block nbd1277: queue cleared

ata1: soft resetting link
ata1: EH complete
ata2: soft resetting link
ata2.00: configured for UDMA/33
ata2: EH complete
block nbd1275: Attempted send on closed socket
blk_update_request: I/O error, dev nbd1275, sector 0

scsi 2:0:2:0: Direct-Access     VMware   Virtual disk     1.0  PQ: 0 ANSI: 2
scsi target2:0:2: Beginning Domain Validation
scsi target2:0:2: Domain Validation skipping write tests
scsi target2:0:2: Ending Domain Validation
scsi target2:0:2: FAST-40 WIDE SCSI 80.0 MB/s ST (25 ns, offset 127)
sd 2:0:2:0: [sdc] 104857600 512-byte logical blocks: (53.6 GB/50.0 GiB)
sd 2:0:2:0: [sdc] Write Protect is off
sd 2:0:2:0: [sdc] Mode Sense: 31 00 00 00
sd 2:0:2:0: [sdc] Cache data unavailable
sd 2:0:2:0: [sdc] Assuming drive cache: write through
sd 2:0:2:0: Attached scsi generic sg3 type 0
sd 2:0:2:0: [sdc] Attached SCSI disk

CIFS VFS: cifs_mount failed w/return code = -95
CIFS VFS: DFS capability contradicts DFS flag