How To Add Additional Storage to an Existing SD-WAN Center VM
Article ID: CTX227039
Updated On:
Description
The objective of this article is to provide assistance on how to add some additional storage from what was initially configured during the initial import of a NetScaler SD-WAN Center VM.
Instructions
The following steps depicts the steps needed on XenServer:1. Shut Down the SD-WAN Center VM
2. Select the Storage tab of the SD-WAN Center VM and click Add.
3. In the “Add Virtual Disk” pop-up window, enter a Name: SDWANCENTER, and size (e.g. 10GB), then click Add
4. Start the VM and navigate back to the browser user interface
5. After the SD-WAN Center VM has fully booted, log back into the web management interface with admin credentials
6. Navigate to the Administration > Storage Maintenance page, Select the newly added storage host and click Apply
7. Confirm by clicking Switch in the pop-up window to delete all existing files
8. Confirm by clicking Switch again to switch the active storage system
9. SD-WAN Center will “enter maintenance mode” to perform this operation, when complete click the Continue button
Issue/Introduction
It is possible to add additional storage to an existing deployment of NetScaler SD-WAN Center.
Was this article helpful?
Yes
No
Powered by
