This article helps you address RMA replacements and includes instruction on how to backup configurations, upgrade or downgrade shipped software version, and setup of RPC password on NetScaler.
Complete the following steps to replace a NetScaler in high availability pair setup:
These files are located under “/var /ns_sys_backup/” directory.
While logged into the Primary NetScaler, run the following commands

Before syncing the new unit to the Primary NetScaler, we need to ensure that both NetScalers are running the same build.
Note: If at this point you wish to change the management IP of the new Secondary NetScaler, you may do so before moving forward.
Now that the new Secondary NetScaler is up to date, it is time to change the password on the new Secondary NetScaler to match the password that is currently on the Primary NetScaler. The following instructions will walk you through the process.
With the password confirmed across both units, we are now ready to bind them to create an HA pair.
At this point, we are now ready to join the NetScaler units into an HA pair. For details regarding this process, refer to CTX116748 - How to Set Up a High Availability Pair on NetScaler.
This article helps you address RMA replacements and includes instruction on how to backup configurations, upgrade or downgrade shipped software version, and setup of RPC password on NetScaler.
Feedback submitted!