Reconfigure XenDesktop Desktop Studio when Installed as a Standalone on a Remote Server
Article ID: CTX131780
Updated On:
Description
When you install Desktop Studio by itself on a remote server, that is, without the controller role installed locally, the first time you start the Desktop Studio Console, you are prompted to select which Desktop Delivery Controller (DDC) you want to connect, as displayed in the following screen shot:
Note: You can reconfigure this to point to a different DDC.
Requirements
Desktop Studio is installed as a standalone on a remote server.Instructions
-
Close the Desktop Studio console.
-
Browse to C:\Users\<Username>\AppData\Roaming\Microsoft\MMC
-
Where <Username> is the name of the account you are using.
-
Delete or rename the DesktopStudio file.
-
Start the Desktop Studio console. You will be prompt again to enter the DDC.
Note: In XenDesktop 7.x, the file name is Studio.
Issue/Introduction
Additional Information
You will not find any reference to the DDC if you open the DesktopStudio file using notepad. This information is stored in the file as a Base64 encoded binary entry.
