How to Reset/Change Timeout Value of Command Line Interface Session on a NetScaler Appliance

book

Article ID: CTX124397

calendar_today

Updated On:

Description

Run the following command to configure the timeout value for the command line interface session:
set cli mode –timeout 1900

Run the following command to verify the timeout value for the command line interface session:
> show cli mode

        Page:  OFF               Total:  OFF
        Color:  OFF              DisabledFeatureAction:  ALLOW
        Timeout:  1900           TimeoutKind:  Climode
        Regex:  ON

Additional Resources

For more operations that can be performed on "cli mode" refer to Citrix Documentation.

Issue/Introduction

This article contains information about the timeout value for the command line interface session of a NetScaler appliance.
Powered by Wolken Software