How to Change the Primary Management Interface on XenServer with XSConsole
Article ID: CTX121235
Updated On:
Description
This article describes how to use XSConsole to update the Management Interface.
Instructions
-
From the XenServer command line, use the following command to go into the Configuration:
xsconsole -
Select Network and Management Interfaces. It tells you the current Management Interface, which is Network 0 or eth0. Then press Enter.
-
Select Configure Management Interface and press Enter.
-
Enter the Username and Password of the XenServer.
-
Select the physical interface that you want to change which is eth1 and press Enter.
-
Select DHCP, DHCP with Manually Assigned Hostname, or Static IP address. This example has Static selected.
-
Enter the IP address, Netmask, Gateway, and Hostname, and press Enter.
Issue/Introduction
This article describes how to use XSConsole to update the Management Interface.
Was this article helpful?
Yes
No
Powered by
