How do I configure NetScaler Gateway to use a Cloud Connector as a STA
Article ID: CTX232640
Updated On:
Description
To use Cloud Connectors as the Secure Ticket Authority (STA) servers
Instructions
The detailed instructions below will walk you through the steps required to update your NetScaler configuration to use your Cloud Connectors as the STA servers:| STEP 1 | From the NetScaler management console, select your existing NetScaler Gateway virtual server and click the Edit button. |
| STEP 2 | Locate the Published Applications section and click the STA Server item. |
| STEP 3 | On the STA Server Binding page, enter the IP address or FQDN of your Cloud Connector. Select the IPV4 option and then click the Bind button. |
| STEP 4 | Locate the Published Applications section and verify the STA Server count has increased. Click the STA Server menu item. |
| STEP 5 | Verify the newly added STA server shows the UP state, indicatingthat network connectivity between NetScaler Gateway and the Cloud Connector is correctly configured. Click the Close button. |
| STEP 6 | Scroll to the bottom of the page and click the Done button to close the Virtual Server page. |
| STEP 7 | Save the NetScaler Gateway configuration changes. |
| STEP 8 | Configure the same STA in the store in Storefront. |
Issue/Introduction
Step-by-step instructions for configuring NetScaler Gateway to use a Cloud Connector as the Secure Ticket Authority (STA).
Was this article helpful?
Yes
No
Powered by
