Error: "vDisk is not available. Please check your network PXE boot configuration and restart Imaging Wizard" or "Red X" on Provisioning Server

book

Article ID: CTX133272

calendar_today

Updated On:

Description

After installing the Target Device Software and rebooting the following symptoms can be seen:

  • A Red X is displayed on top of the vDisk Status Applet in the Tray Bar
  • After running the Imaging Wizard and rebooting the following message is shown: "vDisk is not available. Please check your network PXE boot configuration and restart Imaging Wizard."image.png

Resolution

There are various troubleshooting steps that can help solve this issue.
 

  • After running the Imaging Wizard it will require a restart. At that point ensure that the vDisk is in Private Image mode.

  • Check boot order settings. If you are using ISO to boot, make sure the VM is set to boot from the DVD Drive

  • If using antivirus, ensure to remove the antivirus before installing Provisioning Server Target Device software and creating a vDisk

  • If Symantec Network Threat Protection is installed, remove it from the Image before running the Imaging Wizard

  • Check for additional Network Filter drivers in the Network Card's Properties, such as the Microsoft Network Monitor Driver and disable them
    image.png

  • Ensure there are no filter drivers sitting with higher altitude above the Citrix drivers. If there are, uninstall the software to which they belong.
    Open a command prompt with elevated permission and type fltmc: (Note: luafv and FileInfo are normal Microsoft Windows drivers and do not interfere with PVS)
    image.png
     


Problem Cause

The vDisk might not be available for the following reasons:

  • Wrong vDisk configuration when Imaging the Master Image

  • Boot order is wrong

  • Wrong NIC order is selected.

  • Antivirus software not configured correctly

  • Symantec Network Threat Protection is installed

  • Additional Network drivers in the stack

  • Additional Filter Drivers with a higher altitude than PVS drivers

Issue/Introduction

This article provides troubleshooting steps to fix the error that appears after a reboot when attempting to use the Imaging Wizard and when experiencing a Red-X in the vDisk Status Tray App.

Additional Information

CTX124185 - Provisioning Services Antivirus Best Practices

CTX117374 - Best Practices for Configuring Provisioning Server on a Network