When the HA failover is performed manually, the old primary node can reset all interfaces

---

Instructions

When manually force NetScaler HA failover, for the new secondary node it will NOT, to reset it's interfaces by default.

1. If you want the new secondary node to reset it's interface in this scenario. You may Check the "RESET Interface on HA Failover" option.

• Go system>>network>>Configure Layer2 Parameters
• Enable RESET interface on HA Failover option

NOTE : this option has no bearing on other system auto triggered failover scenarios(like Monitored interface goes down, SSL Card failure. etc.), where the interfaces on the new secondary node are always reset.

2. Click here for more info regarding HA failover interface reset behavior.