Reverse imaging error - Unable to reverse image a vDisk using P2PVS getting "The destination Disk is too small"

• Remove the write cache disk.
• Re-run the P2PVS so that there will be only one physical disk attached to the target device.

Problem Cause

• In this case it is selecting write cache as target drive instead of the other local hard drive that was attached and throwing this error.
• When we perform reverse imaging we need to attach a new local disk to the Target Device.
• In case we have any additional disk even the write cache disk, P2PVS will considered that as the target disk.
• As per the requirement the target disk shall either be of the same size or a little larger than the vDisk size. Write cache being a smaller disk when got selected as target disk, it throws this error.