This article describes how to change the IP address of the NetScaler Management and Analytics System from the command line interface.

Instructions

To change the IP address of NetScaler Management and Analytics System, complete the following procedure:

Note: It is recommended to use the Graphical User Interface (GUI) to change the IP address of NetScaler Management and Analytics System.

1. Open a Secure Shell (SSH) console to the NetScaler Management and Analytics System.

2. Log on using the nsroot/nsroot credentials. For NetScaler 10.5 log on using root/nsroot. Please note these are default credentials
   Note: If you are accessing the management service directly through console on NetScaler SDX or NetScaler Management and Analytics System, the credentials nsroot/nsroot do not work. The credentials root/nsroot work as before and SSH access to the management service also works as before with either of the credentials.

3. Run the following command: (this file is located in the /mpsconfig
   networkconfig

4. Select the appropriate menu and update the NetScaler MAS IPv4 address, Netmask, and Gateway IPv4 address, as shown in the following screen shot: