This article describes how to preview GSLB synchronization on NetScaler 11.1.

Note: This feature is available only in NetScaler release 11.1.42.5 or later.

Preview GSLB Synchronization

By previewing the GSLB synchronization operation, you can see the differences between the master node and each slave node. If there are any discrepancies, you can troubleshoot before synchronizing the GSLB configuration.

Instructions

How To Preview GSLB Synchronization

To preview the GSLB synchronization output by using the NetScaler GUI:

1. Navigate to Configuration > Traffic Management > GSLB > GSLB Configuration > Synchronize configuration on remote sites.

   

2. Select the Preview check-box.

   

3. Click Run.

   

4. A progress window displays any discrepancies in the configuration.

   

Debugging the commands triggered during synchronization process

You can view the status (success or failure) of each command triggered during the synchronization process and troubleshoot accordingly.

1. Navigate to Configuration > Traffic Management > GSLB > GSLB Configuration > Synchronize configuration on remote sites.

   

2. Select the Debug check-box.

   

3. Click Run. A progress window displays the status of each command triggered during synchronization.