How to Force Scriptable Monitors to Use SNIP in NetScaler 10.5

How to Force Scriptable Monitors to Use SNIP in NetScaler 10.5

book

Article ID: CTX217712

calendar_today

Updated On:

Description

This article describes how to force scriptable monitors to use SNIP in NetScaler 10.5.

Instructions

As scriptable monitors cannot use netprofiles even if they are bound to services, the following is one way to force scriptable monitor to use SNIP:

  1. Add ACL ssl-monitor allow -destip<server-ip> -srcip <nsip> -protocol TCP -destport <port>
  2.  Apply ACL.
  3.  Set rnat ssl-monitor -natip <snip>​

Issue/Introduction

This article describes how to force scriptable monitors to use SNIP in NetScaler 10.5.
Powered by Wolken Software