During SDX single bundle upgrade xensever upgrade fails
Article ID: CTX217550
Updated On:
Description
During single bundle upgrade to 11.0.64.34 only xenserver upgrade failed and it stayed on 6.1 instead of getting upgraded to 6.5.
We see below error during upgrade:
Error during single bundle upgrade = unknown management interface found. error code 10008
Resolution
Configure IP address for XenServer as described on this article: https://support.citrix.com/article/CTX205717
![]()
Problem Cause
There was no xenserver IP configured due to which xenserver upgrade failed.Issue/Introduction
During SDX single bundle upgrade all components viz. SVM,supplementary pack, hotfix was done however only xensever upgrade fails
Additional Information
Was this article helpful?
Yes
No
Powered by
