PVS Console Crashes while using XenDesktop Setup Wizard
Article ID: CTX200253
Updated On:
Description
After entering the Credentials to get the list of templates from the Hypervisor, the following error appears:
"Microsoft Management Console has stopped working"
Note: The issue does not occur with XenServer as Host Connections to XenServer do not allow the port number in the address.
Resolution
Remove the port number from the Host Connection on the XenDesktop DDC.
Issue/Introduction
When the Host connection on the XenDesktop DDC has the port number in the URI, it causes the PVS Console to crash while using the XenDesktop Setup Wizard.
Was this article helpful?
Yes
No
Powered by
